We used FlashPrint to add supports to our design. We placed the mouse vertically because of the groove and Flash Print didn’t add supports to it directly. Below, is the final product we got.

Our first iteration of making an Arduino Box with laser cutting didn’t turn out well. The height and the width were off by a few millimeters because of which the Arduino was able to move freely inside the box. The USB hole was perfectly aligned. However, the connector holes were not easily accessible. Below is the […]

This assignment involved designing a case for the Arduino Board. Firstly, we measured the Arduino board using these measurements on FreeCAD. Following were the measurements, (considering some offset to fit the board) Height: 30 mm Width: 60 mm Depth: 80 mm For designing the case, we decided to go with the finger joints. The laser […]

https://namitamhatre411.github.io/assignment2.html

This is the first blog of a series for my HCI course at StonyBrook. The course is taken by Prof. Roy Shilkrot, who was a part of the Fluid Dynamics Team at MIT Media Labs. The first lecture touches on the theory and history of Interaction design. Don Norman’s below video shows that it is […]